JimC

I'm in the process of installing my Zex nitrous kit and the instructions say

"Locate the four wires that go to the throttle position sensor. The wires are located on the

passenger side of the engine’s throttle body assembly. Using the supplied red T-tap

connector, tap into the YELLOW wire. Attach the red crimp-on blade connector to one end

of the white TPS Resistor Wire and plug it into the T-tap connector. Attach the other end of

the TPS Resistor Wire to the white wire from the nitrous management unit. If the white

wire from the NMU is not long enough to reach the TPS Resistor Wire, an extra length of

white wire has been included in the kit."

I don't have the TPS Resistor Wire as far as I can see, just a short white wire coming off my NMU. Can someone post a picture of the wire connecting the NMU and the yellow wire on the throttle body? It appears that I am missing a part and the instructions don't have a picture to tell me what it is.

__________________
Auto, C&L, tune by Lidio, 3.73, Tlok, J&M LCA; LPW cover; Zex; SS Superstripe, Roush scoop. Dual GT500 take offs. Black bullitts. Shaftmaster aluminum drive shaft. 13.87 @ 100.27

Fred Malibu

PM JimKaray and ask him. He has made a HOW TO on his own site. I bookmarked it my my other comp..

__________________

JimC

I've been talking with Jim about other things on the install, and I didn't think to ask him about this part. Thanks.

__________________
Auto, C&L, tune by Lidio, 3.73, Tlok, J&M LCA; LPW cover; Zex; SS Superstripe, Roush scoop. Dual GT500 take offs. Black bullitts. Shaftmaster aluminum drive shaft. 13.87 @ 100.27