will

I am in the middle of converting my 95 5.0 to carb. My problem is the dist I pulled out has a longer shaft from the gear down than the one i'm putting in. AM I GOING TO PUMP OIL OR NOT!!! I see the hyd roller block oil pump driveshafts are diff than the non roller blocks any ideas?

HACKGT350

i've never heard of this. if it doesnt pump oil then get a new drive shaft for the oil pump. best way to tell if your getting pressure or not before you hook up fuel and park crank the engine over and see if you are getting an oil pressure reading on your gauge

__________________

93_5.0_gt

they will both work. only diff is the distance the dizzy is down on the shaft. im running a points dizzy and have no issues at all

__________________
$15,000 and counting

68CSTANG

To the OP, did you ever get it figured out?

__________________


FOR SALE: Cobra upper/lower intake, BBK 70mm TB, K&N CAI, Holley fuel pressure regulator and more. PM for details and pics.

will

Yup I sure did, I stuffed modeling clay in the shaft installed it then removed it. There's more than enough shaft to turn the pump. Been runnin for a week now and no prob. Thank you all