I am replacing my carpet and am wondering what that silver stuff you guys are putting down is. I went to Oreilly and got some silver stuff for under the carpet, but it has insulation on one side. The stuff you guys have looks as though it forms or is sticky. Also, where do I get it? Thanks.
im going to piggy back off this and ask anyones opinion on whether or not the insulation is worth it.
do you see a large reduction in noise?
__________________
My 1967 Coupe
ASE Cert:Auto Collision, Refinishing, & Metalwork/Mechanical Engineering Major. Because being 18 means you know nothing about automobiles
Theres the factory stuff which is ok then theres dynamat hushmat and many other brands and yes any sound deading will kill noise in the car.Many of my friends do car audio and swear the stick down like dynamat lined the whole trunk the car don't buzz and rattle like most you hear going by blasting music.
I don"t know what it is called,but the from what I know both in car audio and general car knowledge I have, It is well worth the time and effort. Even the insulation thatused tohang from your hood helps reduce heat and noise.you may want to make sure it does not retain moisture.
Just be careful not to put stuff in that is too thick it may be hard to re-install the seats and shifter plate etc...
A good example would be to take a ride in a 1969 dodge power wagon (no insulation) if you can still hear,then take a ride in a 2008 cadillac (insulation)
__________________
1970 Ford Mustang Restomod
302/310 est. hp
C-4/B&M Shift kit
9 In. /4.11 Trac-lok Video
I just installed Rattle Trap in my car... it was about $200 for 150sqft of 80mil stuff... it took one of tworoll to do the entire trunk and behind the rear quarter panels doubling up on the wheel wells. It will be a long time though before i get to try it out. but i still have 1 roll for the front of the vehicle, doors, and roof. i can post some pics but i cant tell you about the effectiveness of the product
I used a product called FatMat. I purchased 100 square feet and split it with my cousin. We did both our Mustangs. I would have liked to have a bit more to line my doors. I think it was around $120 shipped. It is very similiar to Dynamat and goes on very easy. It did quiet down the interior. Here is a picture of it installed.
__________________
1964 1/2
289 2bbl (autolite 2100) with holley headers and flowmaster 40s
new: Quick Performance Racing 9" rear, Moser axles, 3.5:1 trac loc from FRPP and T5. CSRP disc brakes front and FRPP discs back. New wheels and tyres
http://www.gascc.ie