i heard the ford racing rockers are good..are you stud mount or pedestal...i just ordered a brand new set of scorpion 1.6 pro race series pedestal mount rockers...i heard alot of people say the crane rockers were noisy
_____________________________
308 performer rpm heads, b-cam, cai, msd6a, cobra intake 65mm tb,mac 1 5/8 shortys, custom 2 1/2 inch h pipe with 40 sereis flows, 373's, cobra maf and injectors, 190 pump and mallory regulator. painted pearl white
Ford's valvetrain stuff for the Windsor family was made by Crane primarily. Even the 1.7 roller rockers used on the 302 Cobras have a Ford emblem and part number on one side, and "Crane cams" on the other.
_____________________________
Who cares how much horsepower it has, all that matters is how fast it goes!
Best run 13.23 at 106.97mph with a 2.183 60' Times from before tune and driver mod.
im about to grab a set of edelbrock aluminum heads ford fcam gt40 upper/lower intake full exhaust no cats bbk equal length headers ford hydraulic roller lifters bore 0.030 over 3.73s 16pony wheels bbk cold air intake 70mm throttle body bbk255 fuel pump bbk pulleys and im runnin that on my 89 gt 5.0. might look into chip and bigger injectors too shud be around low 13s high 12s in the quarter.
my cranes seem to be a little noisy so far not to bad but u can hear them with the hood up and standing in front of it but thats about the only time u can hear them
You should get 24# injectors, as for a chip stay away from out of the book ones and get one custom burned
_____________________________
89 2.3 Turbo, 82 T-Top Notch 5.0, 86 LX T-Top 5.0 roller and 86 GT Black in and out with Gt 40X Heads, Smoothed Engine Bay, Battery in Trunk, SLP's, Bolt-on's
Printable Version
ford or crane rockers? - 
RE: ford or crane rockers? - 
