LXVert89_2.3L
05-11-2008, 08:21 AM
Hey everyone.... I have psoted this question on another mustang forum and I seem to not be getting any help.
My question originally was what the loud hissing was coming from my transmission, and found out it was my vacuum modulator. The hose was frayed. Well, thats fixed.
But my transmission is still banging into gear from park to drive and only shifting @ redline. I played with the throttle under the hood and I think I have diagnosed the problem.
There are 3 cables leading to the throttle assembly. 2 on the top on one that follows under, Im guessing the one that is on the bottom has to do with the transmission shifting? When I push the top of the throttle arm toward to the driver side wheel well, I notice that that cable on the bottom is not being pulled by the assembly... like theres too much slack.
So heres the question. How do I take out that slack going from the assembly to the trans if that is the cable going to the trans?
Its that lowest wire with that short spring around it. The slack and nipple stick out like an inch past the throttle connection so when the assembly moves, the only thing that cable does, is just sits there. I need to pull that inch.. back.
Edit:
I found a picture closest to my setup and youll see that cable, the lowest of the 3.
http://www.9ih.com/scout/ford23int.JPG
My question originally was what the loud hissing was coming from my transmission, and found out it was my vacuum modulator. The hose was frayed. Well, thats fixed.
But my transmission is still banging into gear from park to drive and only shifting @ redline. I played with the throttle under the hood and I think I have diagnosed the problem.
There are 3 cables leading to the throttle assembly. 2 on the top on one that follows under, Im guessing the one that is on the bottom has to do with the transmission shifting? When I push the top of the throttle arm toward to the driver side wheel well, I notice that that cable on the bottom is not being pulled by the assembly... like theres too much slack.
So heres the question. How do I take out that slack going from the assembly to the trans if that is the cable going to the trans?
Its that lowest wire with that short spring around it. The slack and nipple stick out like an inch past the throttle connection so when the assembly moves, the only thing that cable does, is just sits there. I need to pull that inch.. back.
Edit:
I found a picture closest to my setup and youll see that cable, the lowest of the 3.
http://www.9ih.com/scout/ford23int.JPG