Trouble codes after Whipple install

Mustang Forums Mustang Classifieds Photo Gallery Calendars Search Live Chat Contact MF Sponsors
Mustang Recalls Mustang TSB's News Timeslips Timeline Wallpaper Member List Register Login

Trouble codes after Whipple install

Printable Version

Mustang Forum >> Ford Mustang Tech >> 2005 - 2008 Mustangs >> 4.6L V8 Specific >> Trouble codes after Whipple install

Page: [1]

Message

<< Older Topic Newer Topic >>

Trouble codes after Whipple install - 5/10/2008 5:59:08 PM

RF2.1

Posts: 142
Joined: 8/30/2005
Status: offline

Got the Whipple up and running, but the computer has thrown two codes:
P0345
Camshaft Position (CMP) sensor A, circuit malfunction (Bank 2);
P0349
Camshaft Position sensor A circuit, intermittent (Bank 2)

Anyone else had this issue or heard of it? Any advice? Could I have left something unhooked, or is there a bigger issue?

David

_____________________________

*Whipple Crew Member*

Post #: 1

RE: Trouble codes after Whipple install - 5/10/2008 6:09:29 PM

RF2.1

Posts: 142
Joined: 8/30/2005
Status: offline

Disregard the above. Had a "Dee-Dee-Dee" moment. Forgot to plug in the Cam sensor. All is good now concerning the codes. Just have to figure out the heat exchanger water pump now, which I imagine will also be some stupid little error.

David

_____________________________

*Whipple Crew Member*

(in reply to RF2.1)

Post #: 2

RE: Trouble codes after Whipple install - 5/10/2008 6:09:36 PM

hammeron

Posts: 7821
Joined: 5/17/2006
Status: online

bank 2 is the drivers side

check the sensor and the wiring harness
around it

(in reply to RF2.1)

Post #: 3

RE: Trouble codes after Whipple install - 5/10/2008 6:10:35 PM

hammeron

Posts: 7821
Joined: 5/17/2006
Status: online

ok, disregard my post then

(in reply to hammeron)

Post #: 4

RE: Trouble codes after Whipple install - 5/10/2008 7:08:44 PM

moosestang

Posts: 7108
Joined: 9/3/2006
From: Gainesville, FL
Status: offline

You probably have a bad connection at the resistor. Your pump won't run without that. That's assuming you connected the power and ground wires correctly.

_____________________________

whipple HO SC,FRPP springs, Pypes mid mufflers, Che adj. LCA, hurst, 4.10's, 1 piece DS, spec stg 2 clutch. Accel coils 12.52@117.6mph so far with a 2.01 60 ft time(pre shaft, coils, clutch).

(in reply to hammeron)

Post #: 5