Question about toploaders (Full Version)

Mustang Forums >> Ford Mustang Tech >> Classic Mustangs

Question about toploaders

  

valley firearms -> Question about toploaders (5/9/2008 7:27:09 PM)

    Several times my linkage had locked up tighter than ever. I've had to take the rods off the trans and shift the gears manually and then replace the rods. After I do this everything is OK. Anybody have any suggestions? If I remember correctly, my buddy's 65 GT350 used to do it often. 

  
rmodel65 -> RE: Question about toploaders (5/9/2008 7:29:16 PM)

mine has done it, after i first put it in the car, and now i havent driven it in but once out of theyard and back in. i didnt have to replace any rods though.

valley firearms -> RE: Question about toploaders (5/9/2008 7:39:15 PM)

I used the same rods, sorry for the confusion. I just replaced them back onto the linkage arms.

Starfury -> RE: Question about toploaders (5/9/2008 7:40:09 PM)

Sounds like the nuts holding the linkage rods in place are loosening up, or the rods just aren't aligned properly and the shifter is trying to shift the tranny into two gears at once.

Realign the linkage rods and tighten the nuts down real tight.  If it keeps happening, check to see if the rods have shifted at all.

valley firearms -> RE: Question about toploaders (5/9/2008 10:36:25 PM)

I did notice there is some play in the rods. I may also have to replace the bushings. I will take your advice and check the nuts and see if the linkage is bound.

Starfury -> RE: Question about toploaders (5/10/2008 2:24:37 AM)

Not so much binding that I'd be concerned about as loose or improper adjustment.  If the linkage isn't set up right, the shifter won't shift out of one gear before you try to shift into another, which will completely lock the entire unit up.

  

Page: [1]

Return to Mustang Forums home page or view the Full Version of this page.