when i went ot takt of the fenders to finish stripping the sheetmetal of the front end, i found 2!! stripped bolts! im guessing its something the PO did is the only way ot get it out is drilling the tapping a new hole? its the one going into the rocker and of of the bumper brackets
If you have a welder, whether it is stick or mig, do this. If you can see the remaining part of the bolt, take a nut, center it where you can see the stud and weld the stud to the nut. The heat will help with removal. Done right, you should be able to take a wrench to it and remove it. It the nut comes off, just weld it again. Most people are afraid to do this and do not get a good penetration to the remaining part of the stud. Remember: Torch angle definnes direction of penetration. So if you are pointed exactly to the stud, that is where the penetration will be. We do this ALL the time. FEAR NOT!
Printable Version
stripped bolts - 
is the only way ot get it out is drilling the tapping a new hole? its the one going into the rocker and of of the bumper brackets
RE: stripped bolts - 
