Plastic between our hoods and windshields?
Login  | |
|
Plastic between our hoods and windshields? - 3/4/2008 3:06:16 PM
|
|
|
musicheadt
Posts: 348
Joined: 7/28/2007
From: Sterling, Virginia
Status: offline
|
Has anyone drilled or slotted this piece of plastic to allow engine compartment heat to escape over the top of our cars? Am I wrong in assuming cooler engine=more effecient=more HP=faster? I know this plastic piece covers our cabin air filters on the passenger side of our cars. Not all Engine heat would be extracted from below though....since hot air RISES! I wonder if this plastic piece could be strategically drilled/slotted to drop engine temps at all? It has holes drilled into it in the corners to allow water drainage, what would a few more holes/slots do if it dropped engine temps?
......Maybe some mathmetician can calculate what amount of RWHP a 1 degree drop in temperature could get us.
I was joking about the RWHP drop b.t.w. I realize it is completely dependent on you cars specific mods.
< Message edited by musicheadt -- 3/4/2008 3:33:42 PM >
_____________________________
"SKY" has:
C&L CAI BAMA tunes, FRPP Duals W/JBA''s, SS "Eleanor" grill w/center fogs/tri-bar emblem, tints, Xenon side scoops, 1/4 window louvers.
next: Eibach springs and D-specs, 3.73''s, t-loc, X-charger
|
|
|
|
|
|
|
Printable Version
