I have recently installed a new brake power booster with new master cylinder, new lines, and new brakes. I have a new proportioning valve/dist. block that I need to install. The master cylinder has the outlet lines facing towards the passenger side. I was wanting to know if anyone has a good spot to mount this that is not going to interfere with anything. I know it should be somwhere next to the mc and I have the inner apron wall to mount to but any clever ideas will be appreciated. I don't want to have to move it if it is going to interefere with anything. The only thing I can think of that will be in that area is the hydraulic clutch that will be going in later.
Posts: 3143
Joined: 1/18/2007 From: Las Cruces, NM Status: offline
I just attached it to the inner fender near where the stock distribution block mounted, not really creative, but it allowed for short and somewhat attractive tubing runs from the M/C to the P/V.
_____________________________
66 Coupe I-6 Conversion, 408 Windsor, Tremec TKO 600 Wilwood fronts, SSBC Rears 9" Track Loc.
Printable Version
Proportioning valve, mounting locations? - 
but it allowed for short and somewhat attractive tubing runs from the M/C to the P/V.
