yurka

I just bought a gt500 lip for my gt. I was thinking of cutting the holes in the bumper instead of triming the lip, I think it will even hold on better, and look cleaner.
Has anyone done this before?

mlcrycc

There was a guy over on Brad Barnett forum that did it. Must say, it looked good. You may want to search over there......


Mike

Edit...I found it. Start with post 54 and go from there....

http://forums.bradbarnett.net/showth...0+chin+spoiler

__________________

2005 Mineral Grey GT,(1 of 2128 - 12/15/04)...HIS
2008 Highland Green Bullitt (Prod. # 0115).....HERS

ON SEPTEMBER 15TH, 2008, NATE SAID....
congrats brother! skip the Hurst and go straight to MGW, save you the hassle later

yurka

WEll I decided to do it, I think it came out even better this way
Pic not to clear
[/align] __________________

SirKnightTG

If all else fails, use duct tape.

Duct tape, the solution to all of life's problems.

__________________
Show: Vista Blue mirror covers, billet fuel door, sequential taillights, tail light trim, grill light bezel, map light accent, Roush hood scoop, Cervini side scoops
Go: Steeda CAI + Carbon Fiber hi-flow elbow w/ 91 Race tune, Alum DS
2x AeroForce Interceptors
Pocket Pod in trunk
Corsa crew
Vacuum crew

Soon: Shelby hood pins, Kooks LT/cat H, FRPP Hot Rod cams

sonnier

I think it looks even better with the bumper trimming. That's it, I'm definitely getting the GT500 spoiler soon.

__________________
2006 Mustang GT Black, 5-speed