Team MF Member #028 Posts: 4032
Joined: 5/11/2005 From: Newark, DE USA Status: offline
Below are links to the threads that had been stickies in the general section, with new ones subsequently added.
If you know of Technical "How-To" threads here on MF that would be helpful to other members, or if you want to write your our technical thread, just shoot a PM to one the MF Staff Members.
help I have a 1973 mustang convertible with what seems like a 302 I just recently bought a HEI from jegs to change over the ignition. I found top dead center on the compression stroke took the valve cover off identified I was not 180 out etc etc proceeded to drop it in tried my best to line up the rotor with the post I had designated for number one then used the 15426378 firing order all the wires were correct and pop pop started but oh my god sounded just awful shut it down tried the 351 firing order just in case someone used a 351 cam? two days later tried everything under the sun went back to basics several times did notice when it did run for a bit I had no oil pressure on my gauge not to sure about that scared me some wondering about what have I done now kinda thing I was wondering maybe my inexperience with the HEI rotor phasing like a little before the post or a little after the number one post in the cap well any help would be appreciated thnx
Printable Version
"How-To" Tech & Informational Threads - 
