Want to trade Stang for Carpentry tools
Login  | |
|
Want to trade Stang for Carpentry tools - 1/4/2008 10:08:49 PM
|
|
|
Joes 5.0
Posts: 9
Joined: 3/29/2007
Status: offline
|
Looking to trade my 91 GT Mustang for some carpentry tools, I would like to get compressor, nail gun, miter saw, and a circurlar saw. I am a big craftsman fan, but any good name brand is good with me. I rebuilt the motor less than 2,000 miles ago, bored it 30 over, forged pistons, and put a comp cams cam in it with .533 lift intake and exauhst, all new seals gaskets and bearings, a high volume oil pump, and new water pump. Their was nothing wrong with the motor, I was in school to become a machanic and figured it would be a good time to add some power. The body has rust, i have removed the front fenders (still have the 5.0 badges), and started sanding rear 1/4 pannels. Also the paint on the oem body kit is peeling. So i decided instead of spending money, i need to get tools to make money, and pick up a Fox when I can afford and have more room. I stuck over $2,000 into the motor (i can get a receipt from school if you would like) but if i could get the tools listed above, or any reasonable (small items, not another car) trade i would part ways with the stang. Thanks, Joe
|
|
|
|
|
|
|
RE: Want to trade Stang for Carpentry tools - 1/5/2008 4:22:14 AM
|
|
|
jrherald420
Posts: 2584
Joined: 5/28/2007
From: richmond,ky
Status: online
|
wish i knew when i was starting school so i can get out of home building market!!! good luck
_____________________________
02 Mustang GT
K&N CAI,PP PLENUM,FLOW 40s,EIBACH PROs,UPR UPPER/LOWER CONTROL ARMS,STEEDA ADJ CLUTCH KIT,SPEC STAGE 1 CLUTCH+FLYWHEEL,BRIDGESTONE POTENZAS
|
|
|
|
|
Printable Version
RE: Want to trade Stang for Carpentry tools - 
.
