I have a GT500 to stripe tomorrow and cannot find the stripe measurements online anywhere. Can anyone help me out on this. I need the width of the stripe and the gap between. I think it is 1 1/2", but I'mnot sure and this one has to be right. Thanks!

ORIGINAL: grafix66

I have a GT500 to stripe tomorrow and cannot find the stripe measurements online anywhere. Can anyone help me out on this. I need the width of the stripe and the gap between. I think it is 1 1/2", but I'mnot sure and this one has to be right. Thanks!


There is a separate Shelby section in the forum so you might have better luck posting there - maybe someone will run to the garage and measure for you!

Thanks. I finally found them.

What measurements did you find? I'm looking for them as well.

I'm getting mine striped today. Fortunately my friend has one, so I tasked him to go out and measure for me. The bad news is that each section has his it's own size (leave it to Shelby). Here you go:
Front facia: 9 7/16"
Hood: 9 7/16"
Roof: 11"
Trunk: 10 3/4"
My vinyl guy was pulling his hair out, so I just made it all 10 3/4".

Good luck

Thanks, but what about the gap inbetween???

1 1/4"