Parts Needed for m90 Swap

Mustang Forums Mustang Classifieds Photo Gallery Calendars Search Live Chat Contact MF Sponsors
Mustang Recalls Mustang TSB's News Timeslips Timeline Wallpaper Member List Register Login

Parts Needed for m90 Swap

Printable Version

Mustang Forums >> Ford Mustang Tech >> 6 Cyl (V6) Applications >> V6 General Discussion >> Parts Needed for m90 Swap

Page: [1]

Message

<< Older Topic Newer Topic >>

Parts Needed for m90 Swap - 7/26/2007 9:46:13 PM

ÅЯđồľŀễŗ

i have red letters!
Posts: 8486
Joined: 5/15/2005
From: the state of Insanity
Status: offline

This is an extensive list of all the parts needed for mounting and running a m90 supercharger from a Thunderbird SuperCoupe on your single port Mustang. All items are required, unless otherwise noted.

-m90 blower
-SC blower top
-SC lower intake
-SC rear blower intake with SC TB
-Rear intake (from IC to lower intake)
-SC thermostat housing
-SC jackshaft pulley bracket
-SC PS pump bracket
-SC crank pulley
-SC water pump and pulley
-PS pump pulley (you can us your mustang pump)
-SC tensioner pulleys (all 3)
-if using the SC block/crank then use the 94-95 neutral balanced dampener with exeter gear, some dampeners off the F150 will work as well.
-if using the mustang block/crank then use you stock mustang dampener
-if using the SC block/crank then use the SC flywheel/flexplate
-if using the mustang block/crank then use the mustang flywheel/flexplate
-SC heads are better but Mustang heads would probably be fine (SC heads are supposedly a little stronger)
-89-93 SC came with 30# injectors and 55mm MAF (use correct injectors for corresponding year. It matters)
-94-95 came with 36# injectors and 70mm MAF (use correct injectors for corresponding year. It matters)
-all cooling hoses
-SC thorttle cable
-SC throttle cable bracket
-wire to lengthen wiring harness connectors
-extra cooling hoses for custom work
-MUSTANG or SC alt will work
-SC AC compressor
-custom AC lines
-custom air inlet needed
-SC intercooler should work, not sure how well the SC intercooler tubes will clear but they should
or use a custom IC setup
-SC valve covers
-SC oil cooler (not needed but good to have)
-Mustang radiator will work, but if using the SC IC then it might be easier to use the SC radiator its a little smaller though but works.
-Tuning
-SC coil pack bracket (mustang coil pack should work though)

< Message edited by ARdoller -- 7/26/2007 9:48:10 PM >

_____________________________