MAC cat-back not fitting (Full Version)

Mustang >> Vendors & Sponsors >> LM Performance

MAC cat-back not fitting

ant0045 -> MAC cat-back not fitting (7/17/2007 7:29:32 AM)
i have a 95 5.0 and ordered a MAC catback. i can not get it to go over the rear axle. It is the new design so it is one piece not two from the muffler to the tail pipe. Any tips or suggestions. Waiting for mac to call me back. Tried calling at 10:30 today and no ones picking up. want to get the d*mn exhaust on the car. Tried twice already looks like im guna have to drop the rear.

sgtbraddick -> RE: MAC cat-back not fitting (7/17/2007 7:36:41 AM)
That or you can cut the pipe just behind the muffler and have a muffler shop weld it up. That would be the easiest way. The kits should be 2 pc. it would be easier to put in.

ant0045 -> RE: MAC cat-back not fitting (7/17/2007 7:38:43 AM)
like i said i called mac and told them the same thing they told me this was the new style. dont want to have to have it welded again but looks like i might.

sgtbraddick -> RE: MAC cat-back not fitting (7/17/2007 7:54:08 AM)
well I understand about not wanting t cut and weld. As you said before if you can get the back of the car up high enough to drop the diff. it would be more work but it would keep it in 1 piece. Good luck. I'm not sure on the 95's but if you drop the rear check the abs sensors on the axle's you might have to disconnect them if they are there. Not sure if they are the same as my 97

ant0045 -> RE: MAC cat-back not fitting (7/17/2007 2:39:46 PM)
mac has been very helpful so far

Page: [1]

Return to Mustang Forums home page or view the Full Version of this page.