i got mine for $450 new. they are 235/55/17 pirellis. they rubbed a little in the front while turning so i added a 3/8" spacer and now they are ok. they do look a little sunk-in in the rear so i ordered a set of 1.25" hubcentric wheel adapters to bring them towards the fender. they spacers and adapters were less than $80 total. you dont need them, but you may want them after time.
Will wheels from the new '05-'07 stangs fit on an '01 V6? i'm trying to find a set of anthracite pony rims and this info would be very helpful. thanks
problaly, i wouldn' though cause it a totaly differnt chassi than are new edges, remember its a different car, but i could be wrong though. IMO I would just get wheels made for you car year 99-04.
thanks for the feedback guys. i bought rims last night. Bullitt Anthracite. Mustanginexile, where did u get ur spacers?, just so i know in case i have the same problem
for the fronts not to rub i got them at a local parts store (Murray's Auto). You can get them anywhere. I went with 5/8" but non-hubcetric (spacer only). i dont recommend this for a permanent solution as it reduces the size of your studs which can cause them to snap. i put them on temporarily until i can get smaller tires. make sure you have 3/4" of bolt left after you put the spacer on.
to bring the rears to the fender instead of being tucked in i got 1.25" hubcentric spacers off ebay which can be a permanent solution:
really once u spend 100-150 on spacers u will be right at about the price of some take-off gt bullitts that have the correct offsett but hubcentric spacers would work fine for long term i would just periodically check them to make sure they are tight, also put loktite on the spacers
I think American Muscle and Stangmods have some spacers if you're looking.
_____________________________
Straight Shot Intake, Off-Road X pipe, Flowmaster Super 40s, Underdrive Crank Pulley, Lightweight Water Pump Pulley, Bumper Inserts, Smoked Out Taillights, LED Angel Eyes, Blazer Fog Lights...
Got the rims on. they look awesome. didnt need spacers except to bring the rears out a lil bit. rubbing only occurrs when i have the wheel turned to the max and i never turn that hard so for now they are all good. thanks for the advice
Printable Version
Wheel question - 
