|
67SuperSnake -> Rear Seat, Rear Quarters, Carpet & Console (6/2/2007 9:27:54 PM)
|
I cut a piece out of the gas tank filler tube at the tank to make it more level, and not want to spit back at you when filling. Permanently mounted the wiring from the EFI to the passenger fender relays in wire loom. But the big story is I installed the rear inside quarter panels (3 times each to get them right with the roll bar cut out), the rear seats, seat belts, carpet, and console. Carpet is not all the way finished, but is about 80% done (mostly cut, in place, etc. ) I'm not worried about the rear seat wrinkle right now. After it gets out in the heat, if that doesn't do it I might spray a little water on in and rub it in! Like my Mustang rear seat belts? Also, look at the trim moulding where the roll bar meets the rear inside quarter panels. [image]http://i98.photobucket.com/albums/l259/rsowell_2006/InteriorHalfDone.jpg[/image] [image]http://i98.photobucket.com/albums/l259/rsowell_2006/InteriorHalfDone1.jpg[/image] [image]http://i98.photobucket.com/albums/l259/rsowell_2006/InteriorHalfDone2.jpg[/image] [image]http://i98.photobucket.com/albums/l259/rsowell_2006/InteriorHalfDone3.jpg[/image]
|
|
|
|