i need one to measure TDC so i can install my new cam properly... were is a good place to get one and do they have to be ne ceratin lenght... i know there are too kinds... heads off and heads on which is better... how are both used??
Just put the timing mark on the balencer to 0*. make sure it is on the compression stroke. You dont need to find TDC to install a cam, just line up the marks on the timing gears.
__________________
88 GT hatch, 306, Notched TRWs, subframes
x303, 1.6 RRs. 3.73s, 5spd
e7 heads 1.94, 1.6 valve,
perf rpm-24# injtrs, 190lph pump
70mm t/b, 73mm maf, c/a/i, pulleys
o/r h pipe, shortys, flowmstrs, ele fan
UPR u/l, 13.1 on street tires
E7s SOLD, AFR 185's soon
heads arent on but i can put them on... im doin it cuz jay see it needs to be done... he built the cam so that it would be installed a certain way so it needs to be u kno.. im not goin to pay 350 or w.e. it is for the cam and them jus throw it in and not worry about it being rite
Quote:
ORIGINAL: 15austin
Just put the timing mark on the balencer to 0*. make sure it is on the compression stroke. You dont need to find TDC to install a cam, just line up the marks on the timing gears.
considering hte balancer is off im not sure how u expect me to do that.... as for finding TDC yea i do need to so i can make sure my cam is at the correct degree so i have the proper amount of lift at TDC so the custom can is setup like it should be
piston stop
