I've played around a bit with my exhaust. Borla's then straight pipes. Stock cats a off-road X pipe. If you want a great sound.....stock cats with straight pipes. Simple and Cheap. as far as rattle goes, check the clearance between the pan-hard bar and the exhaust. It's a tight fit around the rear axle. Other than that you could check the exhaust hangers for clearance between hook and rubber/brackect. Sweet]
ORIGINAL: rshamekh And .. How did you adjust the Stingers to be aligned perfectly? Mine is sitting a bit low.
Loosen the mid-pipe clamps and over axle clamps. Have a helper align your tip within the bumper cut-outs (in, out, centering.. it's all adjustable), then tighten the over-axle clamp, then the mid-pipe clamp last.
If you already have a tune from brenspeed or most other places for that matter, your O2 sensors will be turned off already. if you don't have a tune I suggest you get a CAI/Tune first then worry about mid pipes. JMO
If you already have a tune from brenspeed or most other places for that matter, your O2 sensors will be turned off already. if you don't have a tune I suggest you get a CAI/Tune first then worry about mid pipes. JMO
Anyone know what size socket I need to remove the down-pipe to exhaust manifold? I know it's gonna have to be a deep socket but what size? I'm using Taco Bill's write up to plan my O/R Prochamber install. I wanna have everything on hand before getting under the car and not have to run to the auto parts store to get the right socket size. Thanks!
_____________________________
MAC Boomtubes, O/R Prochamber, Dynomax Race Bullets(resonators), Tein H. Tech Lowering Springs, Meter4it Tail lights (Chase Mode), 3.55 gears
Anyone know what size socket I need to remove the down-pipe to exhaust manifold? I know it's gonna have to be a deep socket but what size? I'm using Taco Bill's write up to plan my O/R Prochamber install. I wanna have everything on hand before getting under the car and not have to run to the auto parts store to get the right socket size. Thanks!
I believe 15mm or 16mm but I cannot remember. Someone else might know for sure.
Thanks for the replies on the socket size you guys! One more thing...Will I need new gaskets for the exhaust manifold to down-pipe or does it not have gaskets?
_____________________________
MAC Boomtubes, O/R Prochamber, Dynomax Race Bullets(resonators), Tein H. Tech Lowering Springs, Meter4it Tail lights (Chase Mode), 3.55 gears
no gaskets! you're good to go. one more thing....do make sure you use anti seize on the manifold studs so it'll make future switches easier. getting them to break loose can be a b****! pm if you have any trouble....
no gaskets! you're good to go. one more thing....do make sure you use anti seize on the manifold studs so it'll make future switches easier. getting them to break loose can be a b****! pm if you have any trouble....
Thanks! I think I'm ready to tackle the job this Saturday now. I'll post videos/sound clips when done.
_____________________________
MAC Boomtubes, O/R Prochamber, Dynomax Race Bullets(resonators), Tein H. Tech Lowering Springs, Meter4it Tail lights (Chase Mode), 3.55 gears
Printable Version
RE: Pypes Off-Road H-Pipe Install (w/pics) - 
