|
Jefferson -> Mach 1 Chin Spoiler Installation (1/1/2007 10:19:39 PM)
|
This step by step tech article was provided by Durr727.
Thank you Ryan.
Mach 1 Chin Spoiler Installation Guide
Since alot of people commonly ask how-to install a chin spoiler and the details about it, I thought I would make a guide since I was putting mine on anyway.
Tools/Materials: Drill with 1/4" drill bit, Masking/Duct Tape, Push pin rivets/Nuts and bolts.
-I used both bolts and push pin rivets becasue my local auto parts store was out of them, but you may use either.
[image]http://img110.imageshack.us/img110/9210/1sr1.jpg[/image]
1. Raise the front of your mustang using jacks with jackstands or driving your car onto a wooden ramp etc... I used my garage becuase the driveway is on an incline thus I can get underneath my car.
[image]http://img376.imageshack.us/img376/913/2eb2.jpg[/image]
2. Aline your chin spoiler with the edge of the wheels wells and tape it in place. Make sure it is secure because when you are drilling it does move around a little.
[image]http://img110.imageshack.us/img110/6610/3og3.jpg[/image]
3. Check the fitting once you are finished taping it because once you start drilling and putting in the bolts etc... it becomes really hard to start over.
4. Drill 1/4" holes into each of the pr-drilled holes already in the chin spoiler. I didn't use them all, but use the ones needed to properly secure it to the bumper. (ie. ends, 3/4s, middle)
5. Remove all of the tape.
6. Show off you new look.
[image]http://img172.imageshack.us/img172/103/4rn8.jpg[/image]
Estimated Installation Time: 45-60min
Click Here to access the active thread.
|
|
|
|
