Mach 1 Chin Spoiler Installation

Mustang Forums Mustang Classifieds Photo Gallery Calendars Search Live Chat Contact MF Sponsors
Mustang Recalls Mustang TSB's News Timeslips Timeline Wallpaper Member List Register Login

Mach 1 Chin Spoiler Installation

Printable Version

Mustang >> Ford Mustang Tech >> 6 Cyl (V6) Applications >> Mach 1 Chin Spoiler Installation

Page: [1]

Message

<< Older Topic Newer Topic >>

Mach 1 Chin Spoiler Installation - 1/1/2007 10:19:39 PM

Jefferson

Team MF Member #350
Posts: 3513
Joined: 6/3/2005
Status: offline

This step by step tech article was provided by Durr727.
Thank you Ryan.

Mach 1 Chin Spoiler Installation Guide

Since alot of people commonly ask how-to install a chin spoiler and the details about it, I thought I would make a guide since I was putting mine on anyway.

Tools/Materials: Drill with 1/4" drill bit, Masking/Duct Tape, Push pin rivets/Nuts and bolts.
-I used both bolts and push pin rivets becasue my local auto parts store was out of them, but you may use either.

1. Raise the front of your mustang using jacks with jackstands or driving your car onto a wooden ramp etc... I used my garage becuase the driveway is on an incline thus I can get underneath my car.

2. Aline your chin spoiler with the edge of the wheels wells and tape it in place. Make sure it is secure because when you are drilling it does move around a little.

3. Check the fitting once you are finished taping it because once you start drilling and putting in the bolts etc... it becomes really hard to start over.

4. Drill 1/4" holes into each of the pr-drilled holes already in the chin spoiler. I didn't use them all, but use the ones needed to properly secure it to the bumper. (ie. ends, 3/4s, middle)

5. Remove all of the tape.

6. Show off you new look.