Anybody have any projects that are good to do while ur car is being restored? Like lifting the back a few inches? Or fixing the cowl vent? My car is pretty much naked right now except for the doors and engine is there anything that is easier to do while it is like this?
_____________________________
Ya I like "ricers", ya right next to my sweet and sour chicken!
Check for any rust spots. If you have some, i.e. on the floor board, fix them. In addition, my dad and i had a project where we sandblasted the whole body, inside and out... works well, just be sure to get the sand back out. then, start doing any necessary bodywork that will be needed. Or, you could start on suspension/rearend work, the possibilities are up to you.. Do not lose any parts! Also, put all nuts, bolts and screws into small sandwich bags and mark them.. you will thank yourself later on.. Good luck
_____________________________
'68 coupe restoration '95 5.0 18k miles Holley 650 cfm carb conversion, RPM Edelrock Air Gap intake, .498/.512 trick flow bumpstick C6
Printable Version
'66 torn apart, anything i should do while it is like t... - 
