I installed a gt front bumper and lights on my wifes v6 this past week. I ordered the complete wiring kit from street scenes and have everything hooked up and working fine. I had a little trouble with getting there switch to mount in the hole i drilled in the headlight switch panel and ended up having to use a little super glue to get it to hold. Not crazy about the way it came out so i just went and bought a gt headlight switch. There are two wires that go to the add on switch of which one splices into the red and white on the factory switch. I am wondering if i can use the gt switch by just simply splicing the other wire into my existing harness? I'm not sure which wire i would have to splice into however. Can someone give me some instruction on this. I have looked at a couple wiring diagrams but to be honest i can't really make much sense of them.
Thanks Kerry
_____________________________
2002 Mustang GT 622 RWHP/591 TQ MPH 5.0 stoker with a KB 2.2 and a whole lot of other goodies.
2006 Mustang V6 Vista Blue GT front and rear bumpers, grill/lights, rocker trim, 17" bullitts, and gt dual exhaust with a custom h pipe. More to com
got this figured out thanks to Afixer. Since i already had the street scenes wiring harnes in the car all i had to do was disconnect the ss red wire from the factory red/white wire. Then ****e the incoming yellow wire from the kit to the orange/green wire in the factory plug. Now i have the actual gt headlight switch working.
_____________________________
2002 Mustang GT 622 RWHP/591 TQ MPH 5.0 stoker with a KB 2.2 and a whole lot of other goodies.
2006 Mustang V6 Vista Blue GT front and rear bumpers, grill/lights, rocker trim, 17" bullitts, and gt dual exhaust with a custom h pipe. More to com
Printable Version
fog light switch question - 
